640-864 it braindumps

640-864 640-864 640-864 www.cert24.com

Exam Number/Code : 640-864

Exam Name:Designing for Cisco Internetwork Solutions

Version : Demo

QUESTION 1
For the following protocols, which one maps names to IPv6 addresses?

A. Domain Name System (DNS)
B. DNSv2
C. Address Resolution Protocol (ARP)
D. Neighbor discovery (ND)

Answer: A

640-864 640-864 640-864 www.cert24.com

QUESTION 2
What does CDP stand for ?

A. Collection Device Protocol
B. Campus Discovery Protocol
C. Cisco Device Protocol
D. Cisco Discovery Protocol

Answer: D

640-864 640-864 640-864 www.cert24.com

latest IT test materials 642-446

642-446 642-446 642-446 www.cert24.com

Exam Number/Code : 642-446

Exam Name:Implementing Cisco Unified Communications IP Telephony Part 1

Version : Demo

1.
Refer to the exhibit. Company ABC uses 4-digit extensions. To call
between sites, they dial the intersite access code ’8′ followed by the
3-digit site code and 4-digit extension of the phone they are trying to
reach. Phone_A is in Partition Branch1 with a CSS named BR1_External. If
a user dials 85014532 from Phone_A, which element of the route plan
will be matched?
A. Route Pattern 8501! in the partition gateway
B. Route Pattern 8501.XXXX# in the partition gateway
C. Route Pattern 8501.XXXX in the partition gateway
D. the phone with extension 4532 in Partition Branch1
E. the phone with extension 4532 among the partition phones
F. Translation Pattern 85XX in the partition intersite
Answer: F

642-446 642-446 642-446 www.cert24.com

2.
Which dial rule pattern for Cisco 7905_7912 IP phones will allow the
user to dial a 9 for local access, wait for a secondary dial tone, and
then dial a seven digit number?
A. 9404…….
B. 9,*
C. 9,770t5-…….
D. 9,770…….#
Answer: B

642-446 642-446 642-446 www.cert24.com

certification test 642-642

642-642 642-642 642-642 www.cert24.com

Exam Number/Code : 642-642

Exam Name:Quality of Service (QoS)

Version : Demo

1.
As a candidate for CCVP exam, can you tell me what does a router base
its opinion of how much bandwidth is available to a queuing tool on a
serial interface?
A. The bandwidth command is required before a queuing tool knows how much bandwidth is available.
B. The automatically-sensed physical transmission rate on the serial interface.
C. The clock rate command is required before a queuing tool knows how much bandwidth is available.
D. Defaults to T1 speed, unless the bandwidth command has been configured.
Answer: D

642-642 642-642 642-642 www.cert24.com

2.
The “show ip nbar protocol-discovery” command is entered on the SF
router but no NBMR traffic statistics outputs are being displayed. What
can solve this problem?
A. Configure the “ip nbar protocol-discovery” command within the fa0/0 interface configuration mode.
B. Configure the “ip nbar pdlm” command within the global configuration mode.
C. Configure the “ip nbar protocol-discovery” command within the test-in policy-map configuration mode.
D. Configure the “ip nbar protocol-discovery” command within the global configuration mode.
Answer: A

642-642 642-642 642-642 www.cert24.com

dumps free download ST0-12X

ST0-12X ST0-12X ST0-12X www.cert24.com

Exam Number/Code : ST0-12X

Exam Name : Veritas Cluster Server 5 for Unix(STS)

Version : Demo

QUESTION NO: 1

Two applications must either be online on the same system of a cluster or offline on the same system of a cluster. Which Location of Dependency supports this behavior?

A. global

B. local

C. hard

D. Remote

Answer: B

ST0-12X ST0-12X ST0-12X

QUESTION NO: 2

A dependent service group can be brought online on SystemA only if an independent service group is online in the same Veritas Cluster Server cluster. If the independent service group faults, the dependent service group is taken offline. After the independent service group successfully fails over, Veritas Cluster Server will bring the dependent service group online. Which type of service group dependency does this describe?

A. online global firm

B. online local soft

C. offline local soft

D. offline global hard

Answer: A

ST0-12X ST0-12X ST0-12X

QUESTION NO: 3

You have a two-system cluster with a production application on one system and a test application on another. The test and production applications cannot run on the same system at the same time.

If the production application needs to fail over, the test application must be shut down first. Which category of service group dependency supports this behavior?

A. offline

B. global

C. local

D. Online

Answer: A

ST0-12X ST0-12X ST0-12X

QUESTION NO: 4

You are running a Veritas Cluster Server cluster that is replicating to a remote site. Your DBA creates a new volume for additional table space. How could this affect your disaster recovery?

A. The amount oftablespace replicated may now exceed the licensed amount.

B. The additional table space may not be formatted for replication.

C. The number of volumes replicated may now exceed the licensed amount.

D. The volume may not be added to the replicated volume group.

Answer: D

ST0-12X ST0-12X ST0-12X

QUESTION NO: 5

What is the Veritas Storage Foundation feature that allows you to easily get a static copy of replicated data at the secondary site?

A. Snapshots

B. FastResync

C. Data Change Maps

D. Global Cluster Option

Answer: A

ST0-12X ST0-12X ST0-12X

ST0-91X ST0-91X ST0-91X

ST0-91X ST0-91X ST0-91X www.cert24.com

Exam Number/Code : ST0-91X

Exam Name : Symantec NetBackup 7.0 for UNIX(STS)

Version : Demo

QUESTION 1

A company has just expanded the Symantec NetBackup 7.0 environment by adding an additional media server. What is the fastest way to update several hundred Symantec NetBackup clients with the new media server information?

A. run the update_all_clients script

B. run the add_media_server_on_clients script

C. specify the new media server in the Backup, Archive, and Restore interface

D. specify the new media server in the client properties

Answer: B

ST0-91X ST0-91X ST0-91X

QUESTION 2

A tape library had the robot firmware upgraded and now the robot is reading the barcodes with additional characters. What can be set so that Symantec NetBackup 7.0 uses the same characters as before the firmware upgrade occurred?

A. Media ID generation

B. Media ID display

C. media type mapping

D. barcode rules

Answer: A

ST0-91X ST0-91X ST0-91X

QUESTION 3

Which two media status designations are excluded in the count against maximum number of partially full media? (Select two.)

A. Frozen

B. Imported

C. Active

D. Available

E. Inactive

Answer: AB

ST0-91X ST0-91X ST0-91X

QUESTION 4

Five media servers are configured in a storage unit group and media server load balancing is configured. There are 20 backups currently running from ten clients across the LAN. A new backup is started. What is the first criteria Symantec NetBackup 7.0 uses to determine which media server to use for the backup?

A. server rank, based on the Device Management Service

B. the media server that has the most blank tapes assigned

C. server rank, based on the media server performance

D. the media server that has the most free disk space

Answer: C

ST0-91X ST0-91X ST0-91X

QUESTION 5

Some UNIX clients are being backed up using the policy type Standard using the directive ALL_LOCAL_DRIVES. The amount of data being backed up per client in each backup session is much larger than the data available on each client. Which change should the administrator make to avoid the local server data from being backed up repetitively?

A. disable the attribute “Cross mount points”

B. disable the attribute “Follow NFS”

C. add the following entry to the file list “UNSET_ALL”

D. disable the attribute “Collect true image restore information with move detection”

Answer: A

ST0-91X ST0-91X ST0-91X

latest IT exam materials ST0-099

ST0-099 ST0-099 ST0-099 www.cert24.com

Exam Number/Code : ST0-099

Exam Name : Symantec Enterprise Vault 9.0(STS)

Version : Demo

QUESTION 1

What is the minimum version of the .NET framework required on the Enterprise Vault Server for Symantec Enterprise Vault 9 for Exchange?

A. .NET 4.0

B. .NET 3.5 SP1

C. .NET 1.1 and 2.0

D. .NET 2.0 and 3.0 SP2

Answer: B

ST0-099 ST0-099 ST0-099

QUESTION 2

Which feature delegation must be set to Read/Write in Internet Information Services (IIS 7.0) before installing Symantec Enterprise Vault 9 for Exchange Outlook Web Access (OWA) Extensions?

A. .NET Trust Levels

B. .NET Roles

C. Failed Request Tracing Rules

D. IPv4 Address and Domain Restrictions

Answer: D

ST0-099 ST0-099 ST0-099

QUESTION 3

A backup administrator needs to protect the Symantec Enterprise Vault 9 for Exchange server environment. In order to perform a point-in-time recovery of the database, what must be backed up daily?

A. the EnterpriseVaultDirectory SQL database

B. the SQL transaction logs

C. the SQL databases

D. the EnterpriseVaultAuditing SQL database

Answer: B

ST0-099 ST0-099 ST0-099

QUESTION 4

A backup administrator needs to protect the Symantec Enterprise Vault 9 for Exchange server environment. The administrator has yet to run a backup of the vault store partition. The

administrator has Safety Copy enabled for the Vault Store. Given that the administrator has already performed some mailbox archiving, what should occur after running the backup for the first time and clearing the archive bit?

A. The safety copies are removed from the Exchange store.

B. The safety copies are removed from the storage queues.

C. The safety copies are flagged for removal for the next Storage Expiry.

D. The safety copies are flagged for removal when the services are restarted.

Answer: A

ST0-099 ST0-099 ST0-099

QUESTION 5

A backup administrator needs to protect the Symantec Enterprise Vault 9 for Exchange server environment. On which context menu in the Vault Admin Console does the administrator set and clear the vault store backup mode?

A. the Enterprise Vault database

B. the Enterprise Vault services

C. the Enterprise Vault server

D. the Enterprise Vault site

Answer: D

ST0-099 ST0-099 ST0-099

ST0-141 ST0-141 ST0-141

ST0-141 ST0-141 ST0-141 www.cert24.com

Exam Number/Code : ST0-141

Exam Name : Symantec Backup Exec 2012 Technical Assessment

Version : Demo

QUESTION NO: 1
Which Symantec Backup Exec 2012 default global scheduling option allows jobs to be cancelled without manual intervention?

A. job auto cancel after ‘x’ hours after its scheduled start time
B. kill the job if it is still running ‘x’ hours after its scheduled start time
C. terminate the job if it is still running ‘x’ hours if no data has incremented
D. cancel the job if it is still running ‘x’ hours after its scheduled start time

Answer: D

ST0-141 ST0-141 ST0-141

QUESTION NO: 2
In Symantec Backup Exec 2012, scheduled convert to virtual jobs can be configured to support which two sources? (Select two.)

A. all differential backups
B. all full backups
C. most recent snap
D. last incremental with changed block tracking enabled
E. most recent full backup

Answer: B,E

ST0-141 ST0-141 ST0-141

QUESTION NO: 3
Where are the Symantec Backup Exec Job Log files stored by default?
A. \Program Files\Symantec\Backup Exec
B. \Program Files\Symantec\Backup Exec\Data
C. \Program Files\Symantec\Backup Exec\Logs
D. \Program Files\Symantec\Backup Exec\Log

Answer: B

ST0-141 ST0-141 ST0-141

QUESTION NO: 4
For GRT operations, in which two instances must the default path for the TEMP directory specified in "Symantec Backup Exec 2012 > Configuration and settings > Backup Exec Settings > Granular Recovery Technology" be modified? (Select two.)

A. when the default path is the system volume
B. when the default path is a mapped drive letter
C. when the default path is NTFS
D. when the default path is FAT32
E. when the default path contains the Windows page file

Answer: A,D

ST0-141 ST0-141 ST0-141

QUESTION NO: 5
A backup job failed with an access denied error message. Which option in the backup job property can be used to set the correct permissions?

A. verify credentials
B. user account credentials
C. validate credentials
D. test/edit credentials

Answer: D

ST0-141 ST0-141 ST0-141